Strange behaviour since 1.4 firmware update

Since updating when I select loop start and loop end I’m getting weird behaviour. Once loop set I can no longer adjust the loop start and end point on the fly, instead loop end stops the platter and loop start, starts the platter motor again .

you mean this? Loop functionality altered in 1.4

1 Like

yes. I have the same problem. loop modification does not work correctly

Another half-tested, half implemented feature makes it out to the world.

A rough calculation would say that if a manager gets paid 3 times the wage of a programmer/tester then you should get rid of 4 managers and get yourself 12 more programmer/testers

The hardware and the marketing are on-point for Prime already, the support, the firmware and the software need considerable additional programming and testing resources.


This topic was automatically closed 24 hours after the last reply. New replies are no longer allowed.