Power supply interferes receivers of my radio microphones!
I have a case made where two Sennheiser microphones and an antenna converter are installed on the front of the Denon and below on 3U.
As soon as I turn on the Prime4, I get a full-swing interference signal on all two receivers.
When I lift the Prime4 high, the signal is gone.
How / Where do I have to do what to protect the Prime4’s (presumably) power supply?
The following things help:
- Place aluminium foil under the Prime4
- Turn antennas further down
The following things don’t work:
- Change frequency at the receiver
- Set Prime4 to another power outlet
I had a case made for 500 Euros to have the microphones in the case, it would be more than annoying if the Prime4 beamed so strongly that you can’t use Sennheiser G3 (A Band).
I am very grateful for any help!